4-in-1 Remote Control Duplicators Smart Wireless Remote Control
The Remote Control Duplicator is the easiest and least expensive way to copy any wireless remote, car key, garage door opener, and more!
This gadget transfers signals to duplicate your existing remote controls so you always have a duplicate remote or key available in case you lose the original.
The device can clone up to 4 remote buttons from the same or different remotes allowing you carry four remotes in one! Each corresponding letter (A, B, C, & D) can each open a different remote controlled key.
You can open your garage door and unlock your car by using one remote control instead of carrying two keys with you. The seamless infrared connection is secured and safe to use through data encryption. You can copy any compatible wireless remote key and and each password is stored individually.
Type: Auto Remote Control Duplicator
Working frequency: 315/433
Rated voltage: 12 (V)
Rated current: 10 (mA)
Working frequency: 433MHz
Modulation Mode: ASK (AM)
The transmission power: ≤ 100mW
Emission Distance: 100 m (proof)
The encoding type: self Copy
The working temperature: -10 ° C to +50 ° C
Works with the following remote control IC modules (please check your original remote control before ordering),and your remotes also should be Fixed code or Learning code. AX5326-3. PT2262. PT2260. EV1527. FP527. PT2242. HT600. HT680. HT6207. HT6010. HT6012. HT6014. AX5326 4. SMC918. PT2240. HT6013. HT6013. HT12D,etc
Application: garage doors, motorcycles, car alarm products, home security products, short-range wireless remote control products, industrial control products
How to Program:
Step 1 –delete the existing code of our remote duplicator
1)Click and Hold A and B buttons together - Led will flash 3 times
2)Keep holding A button and release B button
3)Keep holding A button and push B button 3 times, Led will start flashing Non-stop
Now press any key on the remote control, LED lights are not bright, so delete code success; if you press the button LED lamp is lit, indicating that the original code is not deleted !
Step 2 - clone your original remote
1)Put both remotes Into back to Back position. Make sure they have direct-contact
2)Click and hold 1 button on your original remote and 1 button on your clone remote. Keep holding until led will make 2 blinks then 3 blinks then goes into Steady and you have successfully cloned. ( the left keys follow the same above operation)
If for some reason the clone does not go further then 2 blinks , it means the signal does not go through, please shift the remote slowly up and down until you get the point where it will go through.
1 x Remote Control Duplicator